PS-100 in W/D/W - Main Amp Volume no longer controls Wet cabs

[dan]

Hey @SonVolt and welcome to the community

The power station’s line out will produce a signal proportional to your head’s output volume. That should feed your stereo FX unit.

The problem I think, is that you are using the PS-100 for your dry signal; this is an entirely separate amplifier. So you have an extra volume control to adjust now.

Once you set the volume to the way you like and the whole rig sounds good. What happens when you turn your amp down? Do you find that the wet signals reduce faster than the dry? Is that the issue?

If I have not understood, please sketch (by all means, badly) a rig connection diagram.

This might also be useful

Can I use a Power Station in a wet-dry-wet rig?

Yes, within a certain context… a wet dry wet rig is typically a center dry sound and then stereo left and right with effects. You have three cabinets, one head, and a stereo power amp. The center is usually the cabinet that’s powered by the head and then you take a line out off the head run that into a stereo effects processor and then the outputs of that into a stereo power amp and the outputs of that into two cabs: that’s your wet-dry-wet, your three sound sources. If that’s too loud, then y…

Regards,

Dan