Powerstation PS no sound when taken off bypass

[dan]

Hi @NarenT

@NarenT

One strange thing it if the speaker out One is used, normal sound on bypass and no sound on operate, but if speaker Two is used, bypass and operate both act like bypass,

This makes sense because the first speaker jack has open load protection. Without anything connected to it, the Power Station is locked into bypass/standby.

You have done a great job of eliminating the other possibilities. Here is the No Sound troubleshooting guide, just check if there are anythings you have not yet tried, Power Station: Troubleshooting Guide

If your line-out functions, then this indeed isolates the issue to the tube side of things, meaning your reactive load is fine.

Can you see the heater filaments of your tubes glow when the unit is powered on? It could be a lot of things, such as a bad relay or even a power supply issue. It would be good to arrange a service.

Here are some options for that:

• How can I send my product to Fryette for a repair (RMA Request)?
• Can I get my Fryette product repaired at a local repair shop?

Regards,

Dan