Power Station PS 2a emitting melty plastic smell from fan

Hello,

I’ve been using my power station with a variety of amps with no issues for about 3 years now. I recently obtained a Matamp GT120 Non Master Volume and I run the volume at about a 9 out of 10 to get that desirable power amp distortion/saturation. I’m attenuating this into a 2 x 12 cabinet.

I’m starting to get this melty, plastic smell coming from the unit after playing for about 15 minutes. The power station is getting hotter than I’ve ever seen it get. It’s definitely not the amp according to my nose. For context, the amp was built new by matamp in 2025 so everything should be in good health there.

Is something going south in the unit or is this typical when attenuating this level of output to bedroom levels?

Thanks

Hi @BufoCurtae welcome to the forum!

That is about as loud as the come; if that is 120W clean, then with master volume on 9 it will be quite a bit more.

Fryette amps are similar power levels, and they all work with the Power Station, for example, the Deliverance 120

You did not mention how it is hooked up but note the 8 Ohm tap on the Power Station is 150W rated,

It’s try the 16 Ohm output, but take care when switching to PS-2A bypass as indicated in the screenshot.

I think the smell is from the reactive load resistors getting too hot. So ensure the PS-2A fan is running; there is excellent airflow around the unit, also good airflow in the room might help.