Power Station PS-2A Crackling and popping

After a few months with the Power Station PS-2A (love this thing so much) it seems like one or more tubes might be faulty. There is a crackling and popping coming from the cab it’s connected to. I’m running a Marshall SV20H into the Power Station. All connections are correct. Disabling the Power Station silences the crackling so it’s not coming from the Marshall.

Any help would be greatly appreciated!

It seems I’m past the warranty for tubes (8 months since purchased new). I’d like to get a recommendation for power tubes though if possible. Thanks.

Welcome to the forum.

We use a variety of powert tubes in the PS-2A since they are pretty forgiving across all brands and they don’t make a big defference in performance due to the design of the power amp.

So pretty much any good quality brand will be fine. We use JJ a lot and generally have good results with them, so that would be my recommendation. Amplified Parts has a pretty good price on thise at the moment.

https://www.amplifiedparts.com/products/6l6gc-jj-electronics-matched-vacuum-tube

Hope that helps.

Dave

Thanks Dave. I’m in Canada and Next Gen is my go to for tubes. I’m assuming the phase inverter tube is fine. Static type crackling and popping is usually an indicator of a bad power tube correct?

Is your signal dropping out along with the crackling? Have you tapped here and there on the device to see if the tapping affects it. I had an issue with one of mine (I own several) and the signal dropped in and out along with some crackling and the tapping pointed to the board behind the jacks. The issue was cold solder joints on that board that’s mounted horizontally on the inside behind the jacks- the cold solder was on where the wires connect to the board. It appears that most of the board components are process-soldered and then the wires are hand-soldered and this was simply people going just a little too fast with their soldering- which is pretty common. Internally they look built very well and are an AMAZING product. I have never before had an attenuator or re-amp unit that I can get to sound dead-on as the amp does but at a lower volume.