Hi so I have the ps2-a and it’s connected to a Friedman plex. I turned the power station on and after a couple seconds there was a very loud popping sound and then the volume dropped. I disconnected the power station and the amp and speaker work perfectly fine. I tried the power station again and the volume is still very low. Is this blown tubes or internal fuse?
Hi @Ajf94
Do you have anything in your FX loop? Can you go through the NO SOUNDS checklist here, Power Station: Troubleshooting Guide I know you have sounds, but it’s the same debugging steps I would ask you to do.
This makes sure it’s not something silly, then we can start to suspect other things, yes like tubes, it could be.
Hi @dan
And yes the only the that I had in the fx loop was a reverb pedal. I had that set up there pretty much the whole time I’ve owned the power station so about 6 months it’s been like that and has worked perfectly. I did check to see if the pedal worked through the front of the amp without the power station even connected and everything works like the head, cabinet and speakers.
Thank you for reply.