Amp not playing only the power station

[Terry]

Hi Boy,

Welcome to the forum!

Can you tell us a little more about your set up? Have you had a chance to look through the Power Station troubleshooting section of the FAQ? Let’s go step by step and start with this:

Power Station: Troubleshooting Guide

WON’T TURN ON Make sure AC cord is securely connected at both ends. Verify the power source with something you know works. Check the mains fuse, and replace if necessary. If it blows again, refer to qualified service personnel. NO SOUND Check input cable. Check volume controls. Make sure the amplifier volume and/or gain controls are turned up. Unplug the FX loop, check for sound. Connect a jumper cable from FX send directly to FX return; check for sound. Connect a jumper cable from Line Out d…

Thank You,

Terry